Roof Flashing and Chimney Leak Repair Newark NJ You Can Count On

Roof Flashing and Chimney Leak Repair Newark NJ starts with finding the actual leak, not guessing. We pull the old flashing, inspect the chimney chase, and rebuild the seal with ice and water shield, new step flashing, and fresh counterflashing.

Serving Newark and nearby areas.

How big is the flashing job?

Flashing rebuild

Removing old step flashing and counterflashing and installing new metal.

  1. 1. Seal and reseal Resealing counterflashing and sealing small gaps at the chimney joint.
  2. 2. Flashing rebuild Removing old step flashing and counterflashing and installing new metal.
  3. 3. Full chimney base Rebuilding the flashing, underlayment, and any rotted decking at the chimney.
  • 9Services from one local team
  • 15Areas served around Newark
  • Camera firstWe trace the leak before we quote
  • Water testWe confirm the joint is dry

What Is Included in Our Chimney Leak Repair Service

Every chimney flashing repair in Newark NJ includes a full diagnostic, new flashing materials, and a water test before we leave. Here is what you get.

NJ Roof Repair Connect — Roof Repair you can rely on

Work order

Roof Flashing and Chimney Leak Repair
  • Full Leak Inspection: We inspect the chimney, step flashing, counterflashing, crown, and surrounding shingles with a moisture meter and infrared camera. You get photos of every failure point and a written explanation of what is leaking and why.
  • New Step Flashing: We remove the old step flashing and install new metal step flashing woven into the shingle courses. We use ice and water shield underlayment at the chimney base to block water from backing up under the shingles.
  • New Counterflashing: Counterflashing gets set into a reglet cut into the chimney mortar joint, then sealed with polyurethane sealant. This is the layer that stops water from running down the chimney face and into the roof.
  • Sealant and Roof Cement: Every seam, fastener, and flashing edge gets sealed with Henry roof cement and a bead of polyurethane sealant rated for freeze-thaw movement. We do not rely on tar alone, because tar cracks within one winter in Newark.
  • Water Test and Written Summary: We run a controlled water test at the chimney and check from the attic side.

What the first visit covers

First visit

We inspect the chimney and flashing, trace the leak with a moisture meter, and show you photos of the failure point.

Chimney leak repair at Newark homes

We handle flashing and chimney leaks on all types of Newark homes.

  • Brick chimneys

    Step flashing and counterflashing on brick chimneys.

  • Stucco chimneys

    Counterflashing set for stucco surfaces.

  • Flat roof sections

    Chimney base flashing on low-slope roofs.

  • Multi-flue chimneys

    Flashing repair on chimneys with multiple flue tiles.

Local Roof Repair team in Newark

Chimney and flashing work at Newark businesses

We repair chimney and flashing leaks on commercial and mixed-use buildings.

  • Mixed-use buildings

    Chimney flashing on commercial-residential buildings.

  • Restaurant chimneys

    Flashing repair around kitchen exhaust chimneys.

  • Apartment buildings

    Chimney leak repair on multi-unit buildings.

What Roof Flashing and Chimney Leak Repair Newark NJ Covers

A chimney leak gets worse every time it rains. Fixing the flashing properly the first time stops the water, protects the deck, and saves you from a much bigger repair later.

Roof Flashing and Chimney Leak Repair Newark NJ is the trade of sealing the joints where your chimney, vent pipes, and roof planes meet the shingles. Those joints fail first because they take the most water and the most movement. We remove the old roof cement, cut back the shingles, install new step flashing and counterflashing, then seal every seam with polyurethane sealant rated for NJ freeze-thaw cycles.

Newark homes take a beating from nor'easters, ice dams, and summer downpours that drive water sideways into chimney mortar joints. If you search roof flashing repair near me Newark, you want someone who reads the water trail, not someone who smears tar on the roof. We use a moisture meter and infrared camera to trace the leak back to its source before we touch a shingle.

roof leak repair in Newark, New Jersey
What it is
Sealing the joints where the chimney meets the roof.
When it helps
Ceiling stains, water in the attic, or loose flashing.
What you get
New flashing, a water test, and a written summary.

How Our Chimney Leak Repair Process Works

Every job follows the same five steps. You know what is happening, what it costs, and when we leave.

  1. Leak Inspection

    We climb the roof with a ladder and safety harness, then scan the chimney and flashing with a moisture meter and infrared camera.

  2. Written Scope

    We hand you a written scope with the price, materials, and timeline before any work starts.

  3. Flashing Removal

    Using a pry bar and roofing hammer, we lift the shingles around the chimney and pull the old step flashing and counterflashing.

  4. New Flashing Install

    We install new step flashing woven into the shingle courses, then counterflashing set into the chimney mortar joint. Every seam gets a bead of Henry roof cement and polyurethane sealant.

  5. Water Test and Cleanup

    We run a controlled water test at the chimney and watch from inside the attic.

Tools and Methods We Use on Every Job

Each method answers a different question. Together they leave very little to guess.

Detects temperature differences caused by moisture in the deck and insulation. We use it to trace the leak path from the attic side before we touch the roof.

Confirms whether decking, insulation, or ceiling drywall is wet. Gives us a numeric reading so we know exactly how far the water has traveled.

Fastens new shingle courses and step flashing into the deck. We set the depth so nails do not tear through the ice and water shield underneath.

Lifts shingles and removes old flashing without tearing the surrounding courses. Clean removal is what allows the new flashing to sit flat.

Applies polyurethane sealant and Henry roof cement in controlled beads along every flashing edge and fastener.

When Newark Homeowners Call Us for Chimney Leak Repair

  • A homeowner in Vailsburg notices a brown ceiling stain spreading after a heavy rainstorm.

    We inspect the chimney and flashing with an infrared camera, find the failed step flashing, and rebuild the joint with new flashing…

    Homes
  • A landlord in Downtown Newark gets a 2 a.m. call that water is pouring down the chimney into a tenant's unit.

    We dispatch an emergency crew, tarp the chimney to stop the water, and return the next morning to do the permanent flashing…

    Homes
  • A homeowner in Forest Hill is preparing to sell and the home inspector flags deteriorated chimney flashing.

    We inspect, document the failure with photos, and complete the flashing repair before closing.

    Homes
  • After a nor'easter, a homeowner in Ironbound finds shingles missing and flashing bent away from the chimney.

    We document the storm damage with photos, repair the flashing and shingles, and provide a written report the homeowner can submit to…

    Homes

How Chimney Leak Repair Runs in Newark, New Jersey

Newark's climate is hard on chimney flashing. Winter freeze-thaw cycles open mortar joints and crack sealant. Summer nor'easters drive rain sideways into flashing that has already loosened.

  • Ironbound

    Dense 2 to 4 family housing with shared chimneys. Many have multiple flue tiles and original brick that needs careful reglet cutting.

  • Forest Hill

    Larger historic homes with tall chimneys and steep roof pitches. We use full safety harness setups on every job here.

  • Weequahic

    Mix of brick and stucco chimneys. Stucco chimneys often need counterflashing set differently than brick.

Experienced Roof Repair professionals at work
  • Ironbound
  • Forest Hill
  • Weequahic
  • Vailsburg
  • Downtown

From problem to finished result.

Slide to compare the photo with an illustrative inspection view. It is generated from the photo, not a measurement.

Roof Flashing and Chimney Leak Repair by NJ Roof Repair ConnectPhoto
  • Ironbound Chimney Flashing Rebuild

    Before: A 1920s two-family in Ironbound had a ceiling stain spreading for 6 months. Two prior roofers had smeared tar around the chimney. The step flashing was rusted through and the decking under it was soft. Moisture meter read 28 percent in the deck.

    After: We removed the old flashing, cut out 4 square feet of rotted decking, installed new ice and water shield, new step flashing, and new counterflashing set into a fresh reglet. Water test passed dry. Moisture reading dropped to 12 percent within 48 hours.

  • Forest Hill Storm Damage Repair

    Before: A nor'easter tore counterflashing off a Forest Hill chimney and lifted 8 shingles. Water was running down the chimney face and into the attic. The homeowner called at 7 a.m. with active water entry.

    After: We tarped the chimney by 10 a.m. and returned the next morning for the permanent repair. We installed new counterflashing, replaced 8 shingles, and resealed the chimney base. Total job took 5 hours over 2 visits.

  • Vailsburg Crown and Flashing Repair

    Before: A Vailsburg ranch had water coming down the inside of the chimney chase. The crown was cracked in 3 places and the counterflashing was missing. The homeowner thought it was a flashing leak only.

    After: We rebuilt the chimney crown with new mortar, installed new counterflashing, and replaced the step flashing at the roof transition. The leak stopped completely.

Chimney and Flashing Problems We Fix in Newark

These are the calls we get most often from Newark homeowners.

Ask about yours

  • Ceiling stain spreading near the chimney

    Water is soaking the deck and insulation. If ignored, the decking rots, the ceiling sags, and mold starts within 2 to 3 weeks in humid weather.

  • Chimney flashing pulled loose after a storm

    Loose flashing lets water pour straight into the roof deck during the next rain. A single storm can push 10 to 20 gallons into your attic.

  • Cracked chimney crown letting water in

    A cracked crown lets water run down the inside of the chimney chase and into the roof structure.

  • Rusted or missing counterflashing

    Counterflashing is the metal strip set into the chimney mortar.

Why Newark Homeowners Call Us First

Flashing and chimney leaks do not fix themselves. Every day you wait, water travels further into the deck, insulation, and ceiling.

Same-Day Leak Detection

We arrive with a moisture meter and infrared camera to find the exact entry point, not the stain on your ceiling.

Code-Correct Flashing Work

We install step flashing and counterflashing to NJ building code, using GAF and Owens Corning materials. No tar-patch shortcuts.

Emergency Response Available

When a storm tears flashing loose at 2 a.m., we tarp the chimney and stop the water that night.

Flat-Rate Pricing Upfront

You get the price before we start. No surprise charges when the job is done.

What you receive after the repair

Clear records you can keep and share.

  • Photo record

    Photos of the failure point and the completed repair.

  • Written summary

    A written summary of what was repaired and why.

  • Material list

    A list of the flashing and sealant materials installed.

Before work starts

A plan in writing

Ask for a written scope

Local Experience You Can Verify

We are a GAF Master Elite and Owens Corning Preferred Contractor, which means our installation methods are audited by the manufacturers.

Professional Roof Flashing and Chimney Leak Repair in Newark

Moisture readings

We read moisture levels in the deck and insulation to see how far water has traveled.

Flashing condition

We check step flashing and counterflashing for rust, gaps, and loose fasteners.

Crown and mortar

We inspect the chimney crown and mortar joints for cracks that let water into the chase.

Is your Newark area covered?

Type your ZIP code or town. If yours isn't listed, call and ask, we probably cover it.

Newark ZIP codes

  • 07103
  • 07102
  • 07105
  • 07104
  • 07107
  • 07106
  • 07108
  • 07112
  • 07114
  • 07101
  • 07175
  • 07188
  • 07191
  • 07192

Towns we serve.

Based in Newark and covering the places around it. Pick one for local details.

View all service areas

Frequently Asked Questions About Chimney and Flashing Leaks

Short answers for the first few minutes. The team can cover the rest.

Still have a question?

Describe what you are seeing and we will point you to the right next step.

+16266300000

We quote flat-rate before we start.

NJ Roof Repair Connect handles roof flashing and chimney leak repair across Newark and Essex County. We diagnose with moisture meters and infrared cameras, then repair to NJ building code. Call +16266300000 for a same-day inspection.

Yes. We run emergency chimney flashing repair in Newark NJ for active leaks, usually with same-day dispatch. If water is coming through your ceiling right now, we tarp the chimney to stop the flow, then return for the permanent repair. Call us and describe what you are seeing.

The three most common causes are failed step flashing, cracked chimney crown mortar, and missing counterflashing. Newark's freeze-thaw cycles open mortar joints, and nor'easters drive water sideways past worn sealant. We inspect all three points on every call, because fixing one without the others means the leak comes back.

Get Your Roof Flashing and Chimney Leak Repair Newark NJ Today

+16266300000

Water is already damaging your deck and insulation. Call NJ Roof Repair Connect at +16266300000 for a same-day inspection and flat-rate quote on roof flashing and chimney leak repair in Newark.

Get in Touch With Us

Call us any time, day or night, if water is coming into your home. For non-emergency estimates, we book same-day or next-day visits across Newark and Essex County. You'll get a real person on the phone, not a voicemail box, and a clear answer on when we can get to you.

Call now+16266300000